2005-2009 Ford Mustang Repair Manual:Engine (4.0L V6):Valve covers
Jump to navigation
Jump to search
Left valve cover[edit | edit source]
- Remove ignition coil assembly
- Remove the fuel rail supply line bracket assembly
- Disconnect the PCV hose from the valve cover
- Disconnect electrical connector at the camshaft position sensor
- Disconnect the fuel rail pressure and temperature sensor connector
- Remove the valve cover bolts and lift the valve cover off. tap gently with a soft faced mallet if necessary to break gasket seal
Right valve cover[edit | edit source]
- Disconnect the electrical connector and the tube from the valve cover
- Disconnect the heater hose retainer from the side of the valve cover
- Remove the wiring harness bracket bolt and the mounting bracket from the rear of the valve cover
- Remove the valve cover bolts and lift the valve cover off. cap Gemini with a soft based knowledge if necessary to break the gasket seal.
Installation[edit | edit source]
- If gasket it is in good condition it can be reused
- Clean the gaskets surfaces with a shop rag and acetone or lacquer thinner.
- Follow removal steps in reverse to reinstall
Torque specifications[edit | edit source]
- Valve cover bolts - 89 inch pounds